HSK 25E Tool ForkMaterial: Plastic
Country of Origin: Made IN USA
Maintenance: Tool forks wear out over time. If the spindle is not clamping the tool properly, it may be the tool fork is worn which causes alignment issues. Always insert and remove tool holders laterally. Tool forks should be mounted in an area to reduce the exposure to cutting chips and debris as much as possible. Replace if worn or damaged. The tool holders and spindle taper must be maintained as well. A clean taper, free of debris and burrs will help prevent the tool from sticking. Apply a light coat anti-seize compound to the taper on a regular basis.
Note: Never blow compressed air into the spindle taper.
Compatibility: Can be used with all HSK 25E tool holders.
Hardware: Comes with two 3mm dowels and M5 SHC screws.
